Home

How would you adapt a new pulley and automobile serpentine belt or drive belt to?

Aug 09, 2007 by skahhh | Posted in Maintenance & Repairs

a dryer? I have a dryer whose replacement belt was only about 1/4" wide and which rides on a pulley nearly double that width. The new belt squeals the plastic pulley tensioner wheel because it rides pretty much on one side of the pulley and so

A dryer belt is only supposed to be about 1/4" - 3/8" wide. The tensioner and idler pulleys are wider than that so repairmen with fat fingers, like me, can get the belt on the pulleys and in the correct configuration without removing the drum

DIY: Replacing a BMW Tensioner - E36 M3

the driver's side and passenger side. The tensioner wheels and the idler wheel also get replaced. Remove the plastic bits from the underside ...

Reverse Trommel Project. part 1

of the project so far has been the wheel and pulley alignment. It walked a lot at first then I centered and leveled/aligned the wheels as close as ...