VR6 bad serpentine belt tensioner sound/noise
For forum purposes. This is what it sounds like when your serpentine belt tensioner is wore out on your vr6.
How to Change a Serpentine Belt On Your Car : Removing a Serpentine Belt Using ...
Step by step instructions on how to remove a serpentine belt using an auto tensioner with expert tips on cars in this free auto repair video ...
Chevrolet and GMC S-10/15 Pickup 2000-2002 4.3L Powerdyne Supercharger Kits PDF Installation Instructions
Writing of this manual C.A.R.B. (California Air Resources Board) exemption is pending. This kit already complies with EPA memorandum 1A, making it smog legal in 49 states providing your states pollution laws do not supercede EPA memorandum 1A.
It is very important that these instructions be followed exactly. Premium unleaded fuel with an octane rating of 92 or higher must be used with this Supercharger installed at all times. Failure to use the proper fuel may cause detonation (pinging) and cause severe engine damage. Never change the crank Pulley or the Supercharger Pulley as this will void the factory warranty (see warranty document on the preceding page) and may cause severe engine damage. To help you with the installation, please read the entire step before proceeding with that step.
Only install this kit on an engine with 0 (zero) fuel pressure to avoid fire, injury and possible damage. Make sure that you have a chemical fire extinguisher handy when installing and/or testing any part of the fuel system. DO NOT install any part of the fuel system, or break open any fuel lines near to any source of heat or flame such as a water heater or cigarette. If you are not a qualified mechanic do not attempt this installation. Instead take the vehicle to a qualified mechanic.
**K10528 DOES NOT COME WITH HEADERS** On kits supplied with headers, Powerdyne strongly recommends taking the vehicle to an exhaust shop to have them install the headers before the supercharger installation.